replacement hotfingers screw.

[jiminyrootkit]

ok, so i know someone on here knows where to get replacement thumbscrews for the i/o hotfingers that come with the crappy little plastic covered one that starts to spin loose after a while.
hook it up.
thx
-f

[mer]

i got one at ACE hardware but probably any hardware store. they have all metal ones with a flattened thumbturn top. it's much nicer than the original.

[DanBrooks]

ACE IS DA PLACE!!!!! AAAAAAAAAAAAAAAHHHHH!!!

:hotrod:

[somewhere]

I use a threaded bolt bent over in a 90'degree angle. Works better then a thumb screw because you can use one hand to tighten it.

[The Glass Fish]

definitely ACE.

[garrick]

ooh, im on my way tomorrow.

[seadal]

Some guy named Brad in Dallas made a few for the shop I was working at. It was a regular screw but it had a dime welded to the flat head slot in the screwhead. 3 years and mine is still good.

[Mike_Aurelius]

Spend a couple extra pennies and get a stainless steel one.

[smutboy420]

If you can't find it just from looking around the hardware store. ask for a " Penny head screw" it should be in the section where they keep all the difrent do dads and gizmos like busings and fastners, o rings. If at a hardware store. Not some place like home depot even if they do have them inless you find some old guy or someone else who has a clue about any thing chances are no one there would know what the heck your looking for. Being as most don't know a screw from a nail as it is.
So make sure you go to a hardware store. If you want to find one.