AIM kiln fuji programming issue......

[teaspoon420]

So I finally decided to program an annealling program into my 99ls/d, everything went well with the programming. I set up all the paramaters for each of the 8 segments, and after combing through every single manual I could find still haven't been able to run the program. at no point is there a choice on the menu the run the program, and I have been through every menu on the controller. So now, my question is........... Is this an issue that AIM caused by not programming it right? or is it a faulty controller? This is kinda driving me crazy as I think I understand the stupid little thing.

[VED]

been down that road

http://www.thegldg.com/forum/showthread.php?t=15048

[Micah Evans]

lets see if i can explain without the controller in front of me,


hold select key until it reads prog
press up once and it should blink run
hit select again and it will run you program....

i think thats it, i literally just set mine 10 minutes ago but i cant for the life of me remember for sure. its just so automatic now. if nobody corrects me tonight ill check again first thing in the morning for an update.

[teaspoon420]

VED you are the man, that was exactly it. my dsp1 was at 255, I swear I didn't change it........ but put it at 245 and problem solved. SWEET annealling now. I love this forum.