Burnt logos

[seadal]

I am doing repairs on a few ashcatchers one says Toro and the other halo. I am worried that the logos will burn off when I heat them up to working temp in the kiln. Is this something I need to worry about?:chilling:

[jeves311]

nope their ceramic labels may change color a little bit or fade from multiple reheatings but they should be good just don't hit them in the flame.

[goldmanglass]

dont touch em and dont leave em in the kiln longer than they have to be

[boxfan willy]

They can burn off if over annealed and they def will fade. They get real matte or evaporate leaving this devit looking trace of the logo. No way around it(besides Hydroflouric), but the customer should know.

I would do them cold and run a quick anneal cycle to do the least damage.

I am not speaking from book knowledge. I have fired over 3000 stickers in the last 18 months. Done a lot of fixes on decal pieces.

Good luck

boxfan