PLEASE help? Fugi PXR-3

[glassnewb]

I found a Fuji PXR-3 on ebay new for $50. I had a AIM 9169 analog model and decided it was time to go digi on this kiln.

Installed the controller, two SSR, a cooling fan and new switch and it works PERFECT. Nice and quiet and heats very fast. it went from room temp to 1000 in less than 15 minutes.

The only problem is the controller wont let me advance the setpoint past 1000? Having worked with many of these controllers in the past I know it should go to 9999 on the digital display. Any ideas?

Thanks in advance.

[elad65]

Range locked by internal firmware? Can you do a full reboot and go back to factory defaults and reprogram?

Elad

[glassnewb]

Fixed it, thanks. If anyone else has this issue with the fuji PXR3 you must change the value of P-dP to "1" in the second parameter block. Easy fix.

[CripSkillz]

Here is a good thread for this helped me out too ..

http://www.talkglass.com/forum/showthread.php?t=27056&highlight=aim+kiln