For Science - What digital kiln controller do you use?

[Chris Juedemann]

Paragon - Sentry 2.0

[menty666]

skutt glassmaster

[Julian]

I have an old Fuji PXR3 - not positive if that's the model #. The PXR3 is the current equivalent.

[LarryC]

Home Kiln uses a Bartlett 3 key. Shop kilns run on Omegas.

[p.j.]

fuji pxr3

[Swampy]

CAL controls 9500P.

It gets used twice a day; early for the 220 fusing kiln, when the schedule is done, I switch over to garage the smaller 110 annealer then it goes into the annealing ramp.

Whilst the fuser is working in the morning, I use a West MC 30/3A set point controller on the smaller annealer to garage it then like I say, switch over to the CAL. That usually happens around 1400hrs.

[Icarus]

Hot Ass Tools controller.

[Mecha]

Orton autofire express.

[Chris Juedemann]

Thank you all! I think that's enough. Unless people want to carry on for fun.

[vetropod]

Fuji PXR3, just for fun.

[Julian]

I have a Juedemann Annealotron 2100 on order... anyone know when those are shipping?

[Ronin]

Fuji PXR3...

I didn't want to feel left out.

[frillcappa]

Pxr3

[Bo Diddles]

Homemade, with a cheap eBay "Auber SYL" controller. Has run perfectly for over three years, two of those years on a full time basis. <Knocks on wood>

[stsang14]

Fuji PXR3
Sentry 2.0

[Abe Fleishman]

Omron

[Greymatter Glass]

Digitry GB-1

[Mecha]

HAL 9000

Open the punty bay door HAL......

[Bo Diddles]

I'm sorry Dave, I'm afraid I can't do that.

[Pogo]

Orton 3 button.

[spanglerc]

Omron E5CX-CTC, just finished building it for a 120v kiln that I also built