View Full Version : Ground glass joints
Fire on the mountain
06-27-2005, 12:26 AM
I was wondering how to make glass on glass slide pieces. Is it acid etched or what??
medicatedMELTDOWN
06-27-2005, 01:52 AM
what you need is silicon carbide grit and some water....you put the grit where you want the GonG seal between both pieces and get it a bit wet and twist them together for a long time............maybe theres another way but thats all i can think of
somberbear
06-27-2005, 06:40 AM
buy the joints....... shaft has em... many many lab supplies...
then ya just seal them up...
the stiles normal are just bowl on top of the male joint and a down stem on the bottom.... the female attached to the body....
ericsgreen
06-27-2005, 12:45 PM
ABR has them, and they have the transistion, I guess we call it a downstem or diffusor :) they were out of srtock when I ordered...
you need 19/22 or 19/38 for 18mm gong and the 14/20, I think for 14mm...
but I did see a guy with a custom ashctacher, he said the guy used etch all to make it, sheesh would that suck when for $4 you can jsut get them...
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.