Graphite Parchoffi Jim moore

[SexualHarassmentPanda]

I am employed to make goblet feet, A lot of them. I was gonna buy the cup jacks but now i am thinking the Graphite Parchoffi may be a better tool for this. ANY tool marks are unacceptable to me and object would just get tossed.. Any thoughts? I mean I can make mean foot with a 1/4 carbon rod and centrifugal force but still thought the Graphite Parchoffi might be a good investment.

Thank you

[Mac Maestro]

I don't use a tool. 100% centrifugal force.

[Logan]

Yep, no need for flaring tools on feet. Its all the about the bubble setup and hole opening, then it practically flares itself with the right flame. I like a nice squashed disk shape, then solid connection on the end and use the v tool to score and crack a perfect hole from the point. Build up an even heat base, hottest at the opening, elbo up until the very end, heat, spin, done.

[Mr. Whale dick]

Tool = tool marks

Spinning out is the only way ive seen to not get tool marks

[jesse dog]

but if you were to go with a tool, it's impossible to go wrong with Jim Moore; that is a tool for life