sig marbles...

[dnug42]

I have been doin bunch of signature marbs for some pipes- I got the implossin down but the sig keeps slidin off to one side on some-? how can i prevent that and keep it nice and centered?
I did notice useing mico stringers helps keep it small and clean....the signature

[akmewon]

When you pull it are you doing the pull with a rod with a maria that covers your whole sig plus just a little?Are you making sure to write it centered on the bubble?thats all I got.

[dnug42]

i am just imploding it to a disk- then poppin it off tube with a rod on back of disk and rounding out front of disk into marb. and its happing mostly in the rounding out part...the design will start to slide off to one side....not everytime, sometimes- arm up and arm down are playin big roll- so i am jus tryin to fine tune it...tks!

[Slow]

Lots of good info in this thread (http://www.talkglass.com/forum/showthread.php?16710-signature-milli-tricks).

[yoloswag420]

spin the opposite direction to insure its all heating evenly

[dnug42]

oh, that was a sweet tut...how did i miss that one? well that should save so time....sweetness! tks.