Fuji controller not reading "ProG"

[Prismic Glass]

I just got my aim kiln 99LS/D second hand. I have it programmed and i was going to run it to make sure it all went well before i used it with glass. I was ready to start it but when i was looking for ProG on the display to start it, it was not coming up. The only things that show are LoC, STAT and DSP1. If anyone knows what is happening can you please help me out? Thanks.

[snoopdog6502]

Good luck, those a a tad bit tricky.


http://www.mountainglass.com/Products/INSTRUCTIONS-FOR-FUJI-CONTROLLER/

[Shapeshifter]

You must unmask it. Look in the manual. In the third block there is a dsp1-13. In those parameters you can set it up to mask and unmask the settings to fit your needs. In each one of those 13 parameters you can adjust the number form 0 to 255 I think. In the manual it will indicate where to set these numbers depending on your needs. Programming these can be a pain if you are not familiar. Calling aim kilns might help also. They may be able to walk you through it.

[Shapeshifter]

I was assuming you have a Fuji PXR-3

[snoopdog6502]

Glass hive has a pretty good run down on the fuji. Better then the mountain glass.
I read this glass hive page long ago and decided Im not buying that control on anything. I use a user friendly control.

https://www.theglasshive.com/pages/programming-a-fuji-controller-fuji-pxr3-instructions

[Prismic Glass]

Hey thanks for all your help guys. I Found the masking settings on another forum and cant wait to get to work!
In case it helps anyone else, here are the default setting numbers for the Fuji PXR3
DSP1 - 252
DSP2 - 63
DSP3 - 253
DSP4 - 255
DSP5 - 255
DSP 6 - 1
DSP7 - 0
DSP8 - 0
DSP9 - 128
DSP10 - 255
DSP11 - 255
DSP12 - 255
DSP13 - 127

[Shapeshifter]

Prismic Glass that is a great post. That will help a lot of folks out.