pugs
03-31-2018, 11:51 AM
Just wanted to say thanks to members here for helping me figure out how to cut the stuff. Built the machine from scratch and finally have it dialed in (been a long time, but doesnt get used everyday or anything). Currently cutting 65x2.2mm up to 120x3mm Duran tubing. Been getting it figured out to where I finally was able to cut up 6 tubes worth and only scrapped one pc that was my fault for not preheating enough before diving the torch in to flame polish the ends. My single biggest issue was trying to use a diamond dresser point, which was to broad a point and was not scratching well enough, switched to a diamond scribe pen and nice sharp point, also not using water on the outside helped alot as well.
https://www.youtube.com/watch?v=P0G4ZZCINl0
Some 65x2.2 and 75x2.2mm To be used as an insulated glass lantern chimney for a small rocket stove I make for a customer.
92342
https://www.youtube.com/watch?v=P0G4ZZCINl0
Some 65x2.2 and 75x2.2mm To be used as an insulated glass lantern chimney for a small rocket stove I make for a customer.
92342