Re: steaks thread - newbie progression
Re: steaks thread - newbie progression
rockin setup man, nice kiln too OH DANG didnt see the blasting machine at first, NICE!
i gotta get a mirror on my bench asap
Re: steaks thread - newbie progression
Re: steaks thread - newbie progression
Slits you can do with a dremel and a diamond cutting blade or a tile saw. There is a thread around here somewhere on multi-hole tubing but I can't recall where..
And I LOVE your slides. Always always look great
Re: steaks thread - newbie progression
you can pop 3 or four holes by plugging the first hole you pop with a reamer, i condense the bottom of the downstem to a nice small hole first then pop holes usually 4 or 5
Re: steaks thread - newbie progression
cool i even have a dremel with a diamond blade, but i will also try the po method, i thought about nearly popping them and the opening them up one after another
oh and thak you very much
kind regards frank
Re: steaks thread - newbie progression
Re: steaks thread - newbie progression
lookin good dude!! i need to buy me some frit to play with..
Re: steaks thread - newbie progression
lookin good, you've progressed a lot
Re: steaks thread - newbie progression
was talkin with you on FB, really good progress man
Re: steaks thread - newbie progression
Re: steaks thread - newbie progression
Re: steaks thread - newbie progression
Re: steaks thread - newbie progression
Re: steaks thread - newbie progression
Re: steaks thread - newbie progression
good lord man, there is very close to 200 pictures on this page of this thread! i cant wait till you turn the page, it takes aeons to load now. nice AP striking, nice work, well documented :)