Can someone please tell me What pressure do you use on this torch.
Franklin
Type: Posts; User: franklin sankar; Keyword(s):
Can someone please tell me What pressure do you use on this torch.
Franklin
Does anyone else get a beeping , how did you fix it?
Franklin
Thanks for the replies. Yes it's a low oxygen alarm. Lucky you to find such a place to repair the conc.
Wish I was there but I have to go it alone. Anyone know wher to get zeolite for devilbliss 5...
Visionaire V oxygen conc beeping after half hour. Measured pressure. 8psi constant. Not sure about oxygen level but it is low . flow rate still ok.
Any help on possible causes?
Help greatly...
Ok found it.
Thanks
Where is the Zeolite canisters? Sorry I have to ask . I am working blind without the repair manual.
Regards
Franklin
I forgot to mention that the compressor ports (the two vertical parts at the top) gets hot some time after turning on. Is that normal.
Franklin
You all are the greatest. Thanks so much. I was looking for something that don't exist.
The manual in the reply is an operations manual. I was looking for the resistance value I should get when I...
I have a visionaire V airsep concentrator. Can someone please tell me where the filter is located.
I am getting a loss of oxygen sort of like in pulses. I blocked the outlet line with my thumb and...
So it has been some time since you cut the speaker. Do you now see any deterioration in the oxygen supply now? The low oxygen light should come on.
Thanks
Franklin
Thanks for the hope you bring to me. Can you recycle zeolite by heating?
Franklin
I measured the output pressure and it was ok at 8 pasig . Steady for w while . Can't keep gauge on output for long because it will put too much back pressure. I did not use the measurement point...
Also where did you get the zeolite.
Thanks
Franklin
Ah good idea. Ducting Hmmm bigger box. Ok
Franklin
Should I be concerned about the humidity. Thinking about putting the conc in an enclosure together with a dehumidifier. Fresh air intake to replace the oxygen?
Franklin
That is pretty low working pressure glad to know it works. Thanks for the figures. Most useful
Franklin
Sorry Jr but I am not that fortunate to get med units so easy. It cost me about 3 times the cost of what you pay to import one to where I live. So I really appreciate any advice from the folks who...
Thanks Joe especially for sharing the experience on the wait time . Just could not figure how it did not show up and alarm sooner. Makes sense.
Hope it is a leak. Last time I opened it see if there...
The beeping from an oxygen conc can mean it's outputting low oxygen purity.
So mine starts out ok then an hour later it starts to beep. I hear the compressor switching. I pull the flow dial down...
Thanks Byron. I like your answer. If I had to drop the flow rate, the alarm goes off and I get discoloured glass.
Franklin
I ramped up my flow dial and a few hrs after I am getting a low purity alarm. Beep, beep,beep.
I don't care about the purity flame is still working good,. Is it ok to ignore the
alarm
...
The humidity is high where I am so I put a dehumidifier in a big cabinet/box with the oxy gen. just to make sure the air is dry. Seem to work well so far.
Franklin
I was. Thinking about a ribbon burner and a blower instead of another torch. I use soft glass.
Franklin
Thanks for the replies. My glass is turning brown so I need more oxygen. If I turn it down I get more purity ie more oxygen content but if I increase the flow I get more flow of a lower purity. I...
Is there any problem in ramping up the flow control on my oxygen generator to max , where the ball in the guage is sitting just above the top which has a (red) line ?
Manual has no warning but its a...